|
Challenger™ Agitators are hand crafted and precision machined to
maintain a clean, efficient mixing action with minimal wear on seals and
bearing components. Challenger™ agitators are constructed with solid
shafting that extends the full length of the mixer. The spokes are fabricated
from steel plate and then polished with a grained finish. The spokes are
welded 360° around the shaft with large radius fillet welds for ease
of clean-out. The agitator assembly is then machined in a lathe to remove
any heat distortion in the seal and journal area of the shaft. Shaft run-out
of every Challenger™ agitator is held to within .004” throughout
the seal area. This extra step minimizes wear of seal components and prolongs
bearing life.
| Challenger™ Triple Action
Ribbon Agitators | Challenger™ Cross Action
Paddle Agitators | Challenger™ Combination
Agitators |
Lowe Industries Inc.
3575 3rd Avenue
PO Box 626
Marion, Iowa 52302
Phone: 319-447-9724
Fax: 319-377-1204
|
